| Product Information |
| |
| « Back to product list |
| |
 is specially formulated for a more porous surface that requires to be stabilised,
bonded and sealed. RENO-DRY 2R provides excellent long lasting weather protection
to stone, masonry, brick, mortar, concrete and cement-based paints. |
| ADVANTAGES:
RENO-DRY 2R has all the advantages of Reno-Dry, plus
some more important features. |
| • RENO-DRY 2R
will reduce spalling or flaking masonry. |
| • RENO-DRY 2R
will reinforce and hold deteriorating stucco that cannot
be sandblasted or otherwise cleaned. |
| • RENO-DRY 2R
is ideal for sandblasted stone and brick that has become porous and flaky.
|
| • RENO-DRY 2R
is excellent for new concrete to give a long lasting weatherproof transparent
surface. |
| • RENO-DRY 2R
has a low surface tension, making it very invasive so enabling it to penetrate
well into the surface up to a depth of 1.5mm to 3mm. |
| • RENO-DRY 2R
is both acid and alkaline resistant and is unaffected by salt spray. |
| • RENO-DRY 2R
eliminates spots, stains and streaks due to moisture
penetration of soot, grime or weather conditions. |
| • RENO-DRY 2R
does not change the breathing characteristics (circulation of air through
the wall). |
| SURFACE PREPARATION:
All surfaces must be clean, free of any surface coating
and dry before application. |
|
APPLICATION: Application
shall be by low pressure spray, brush or roller applying sufficient material
to allow a run down of 150mm to 300mm depending on the density of the
surface. Over-spray or splashing on other exterior oil or water based
paints is harmless and can be left without damage. RENO-DRY 2R can be
applied at any temperature, dries within hours and becomes fully effective
within 24 hours. |
| COVERAGE: Application
should be made at the rate of 1 to 2 metres per litre depending upon porosity.
|
| NOTE: Dense
masonry may not accept RENO-DRY 2R at this rate. Such surfaces should be
given two coats and the coverage extended to 1.5 to 2 metres per litre.
At least 2-4 hours should be allowed between coats. |
| AUTHORITY:
Conforms to British Standard BS6477 (1984) - Water Repellents for Masonry
Surfaces. |
| |
| « Back to product list |
| |
