| Product Information |
| |
| « Back to product list |
| |
 is a development successfully combining organic and inorganic materials.
The active element in RENO-DRY is a modified silicone resin bearing a close
relationship to the mineral silicate in the masonry itself. This results
in outstanding effectiveness and durability. |
| RENO-DRY
is used effectively on brick, mortar, concrete, stone, cement blocks, stucco,
abode, sandstone, limestone, cement-asbestos siding, ceramic, clay tiles
and over cement base paints. RENO-DRY is completely invisible and does not
change the colour or texture of the surface over which it is applied. |
| ADVANTAGES:
|
| •
RENO-DRY penetrates deeply into the surface and provides an invisible
silicone lining in the microscopic pores of brick, concrete, stucco and
other masonry. |
| •
RENO-DRY actually changes masonry surface characteristics
from hydrophylic (attraction to water) or hydrophobic (aversion to water).
|
| •
RENO-DRY eliminates or significantly minimizes efflorescence. |
| •
RENO-DRY eliminates or greatly retards spalling and cracking. |
| •
RENO-DRY reverses the effect of surface tension that draws water
into untreated masonry. |
| •
RENO-DRY is both acid and alkaline resistant and unaffected
by salt spray.. |
| •
RENO-DRY eliminates spots, stains and streaks due to moisture penetration
of soot, grime or weather conditions. |
| •
RENO-DRY does not change the breathing characteristics
- circulation of air through the wall. |
| SURFACE
PREPARATION: All surfacesmust be clean, free of any surface coating
and dry before application. |
| APPLICATION:
Application shall be by low pressure spray, brush or roller applying sufficient
material to allow a run down of 150mm to 300mm depending upon density of
the surface. Over-spray or splashing on other exterior oil or water base
paints is harmless and can be left without damage. RENO-DRY can be applied
at any temperature, dries within hours and becomes fully effective within
24 hours. |
| COVERAGE:
Application should be made at the rate of 1 to 2 metres per litre depending
upon porosity. |
| NOTE:Dense
masonry may not accept RENO-DRY at this rate. Such surfaces should be given
two coats and the coverage extended to 1.5 to 2 metres per litre.. At least
two to four hours should be allowed between coats. |
| AUTHORITY:Conforms
to British Standards BS 6477 (1984) Water Repellents for Masonry Surfaces. |
| |
| « Back to product list |
| |
